...stub shaft off a 1984 turbo -350 transsmission stub shaft how to remove and replace it with 2'' longer stub shaft I have 2 transsmission 1 stub shaft is 2" longer then the other stub shaft is affixed ...
Question about 1983 Silverado
right drive shaft loose feeling where splined female goes on maLE TRANNY STUB SHAFT front right drive shaft is loose feeling where female end goes over male stub shaft from tranny cv joint is bad.
...does not come out of front diff unless you drop or remove whole front diff assembly will have to remove whole stub axle hub assembly to remove drive shaft from outer wheel stub axle (hub) ...
...stub shaft retaining ringon transaxle assembly. insert small pry bar between transaxle case and inner CV joint by prying on it.remove strut assembly to steering knuckle bolts remove top of steering ...
...stub shaft out of the transaxle? That is the kind with a roll pin to hold the axle onto the stub shaft. Use a hammer and proper sized punch to drive out the roll pin. It fits in a hole in the center ...
Question about Separate type GPS radar detector machine /CR920si
...stub shaft out of the transmission, and the axle's inner CV housing has a female end that slides over the stub shaft. This set up has a roll pin through the CV housing and the stub shaft, securing ...
Question about Separate type GPS radar detector machine /CR920si
...shaft should bolt to the Trani Stub with 6 (or8) allen keyed bolts. If I had to guess, I think the mechanic may have ruined the seal at the half shaft bolt up point. Maybe he was a bit ******* the ...
Question about Separate type GPS radar detector machine /CR920si
how to take stub shaft out of cv shaft on 2008 huyndai sanafee To remove the stub shaft, just remove the inner CV boot and the spring retainer and the entire tulip and stub shaft will come off
Question about Separate type GPS radar detector machine /CR920si
The shaft stub was left in the transmission when removing CV axle on 04 montana. How do I remove or remove cog from new axle? The "stub shaft" should have come out with the axle.
Question about Separate type GPS radar detector machine /CR920si
is the size and thread of a Mazda rustler 2000 model rear stub shaft The rear stub shaft on a Mazda Rustler 2000 model has a diameter of approximately 1.22 inches (31 mm) and a thread pitch of M20x1.5
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions