Questions & Answers for: strut tower bearings

strut tower and bearing plate my car was hit on the driver side where the front corner panel and door meet. in repairing it, they shifted the strut tower (not sure why) and now i am hearing a creeking

...likely strut bumpers and the strut plate bearings are loosening up, they are at the top of the strut towers and bear the load from the strut, these make that popping sound while traveling over

...STRUT TOWER SOME YOU HAVE TO DRILL THE SPOT RIVETS OUT ON TOP PLATE AT STRUT TOWER BUT MOST CAN BE CORRECTED BY INSTALLING NEW SET OF QUIKSTRUTS I CALL THEM YOU CAN GET THRU LOCAL PARTS HOUSE STRUT ...

...ford 100 transit The most common cause of the noise you describe is the strut bearings in the top of the strut tower.They are a sealed bearing and can,t be greased,one or both should be

...strut. Buy them as a complete assembly much easier and safer to put in .and comes with that part & will give better ride, cause it comes with new spring,also and is not much $ more. Hope this is ...

...strut tower. If you have rack and pinion, the hydraulic rods can be bent. But I would go more with the Balljoints because a bad rack and pinion would affect steering effort but not change the tire ...

I need to know the names of all of the parts that make up a complete rear strut assembly for a 2002 dodge stratus SE sedan. coil spring, strut cartridge and strut tower bearing

...if you want to change the struts and springs or just struts. Struts can be replaced without replacing any other parts.However u should check the bearings that the strut turns on at the strut

...tower. You need to jack the wheel up and turn the wheel left and right to check, also grab the strut and wiggle it back and forward.If there is movement or noticeable noise coming from top of strut ...

...noise only when turning left and pushing the gas? I do need to replace the struts This can be a C-V joint or hub bearing. If your style of front strut has a tower bearing, that's another