...stove and it keeps giving a f 2 code when I turn oven on . I have to hit cancel to make it stop and then turn the oven on again, then in 5 to 10 minutes it F2 again. In december I had a new computer ...
Stove replacement? Kenmore ( Roper) model # 911.7359181 when the stove gets plugged in and the clock gets set it will start flashing F1 and beeping. The only thing that stops it is to unplug the stove
fes330 roper stove power to stove ...ok no fault codes on display normal "stove on" lites....ok normal appearance except no heat from 4 eyes and oven below you have no heat at all? K, pull stove out ...
...F2 when it wasn't even in use! It stops when I push cancel and then starts beeping again within 30 seconds.To stop it I have to flip the breaker off(much easier than unplugging it). The stove ...
my roper electric stove errors E1 F2. I push buttons to stop it but it sometimes does it again. Why does it do this and how can I make it stop? http://www.applianceaid.com/fault_codes.html
I have a Roper Microwave mounted over my gas stove What are the recommended clearances from the top of a gas stove to the microwave? Usually you should have at least 12" - 18" AND a fireproof "Barrier
I have an electric Roper range with the digital controls for the oven. I keep getting the F2 beep and sometimes it won't let me bake. I used it once today and then tried to make brownies. It ...
Question about FGS326RD0, FGS326RD1, FGS326RD2, FGS326RD3 Stove Oven Range Repl
F5 E1 error won't go away Can I just bypass the error code F5 E1 so it will stop beeping? I don't need the self clean mode or door latched. You cannot bypass it. You can check for a broken door latch ...
Question about Stove Temperature Sensor Replacement Range Oven Sensor 334300
Do you know of a Whirlpool part 3188987 wiring diagram? The stove is Model # 2126L0A with a serial number of: 6T60025 try this link erepairparts com
Question about FGP210 Gas Kitchen Range
broiler pilot light works. Why won't stove top pilot light? i know where the pilot light is but stove pilot light will not light, it has been cleaned etc. The pilot orifice may have gotten ...
Usually answered in minutes!
22 Questions
19 Questions
12 Questions
16 Questions