Question about Officejet 7210 All-In-One InkJet Printer
...same issue. The sponge is stuck on two plastic tabs that jut out, one in front of the cartridge stopper?a platform that is normally retracted but which extends if you shut the power off?and the ...
Bad hard drive on n5350 Do I need to remove the key board to to replace it? if so how? Most laptops keep the hard drive on the bottom side. There is a cover screwed over the area with usually 2 screws
Question about Pavilion DV4000 15.4" LCD LEFT AND RIGHT HINGE SUPPORTER - 403921-001 (403921002) CD-ROM Drive
...its a pretty easy job only tricky part is getting screen fascia off easilly!! behind the rubber stopper on screen fascia you will find screws and voiila your half way
Question about Pavilion dv9000z Notebook
looks like it is for speakers has a plastic plug in it from factory. Any solutions? Pull the little stopper out ... it is for head phones ... speaker connection should be in the back
Question about Officejet 5610 All-In-One InkJet Printer
...and rounded on the other half. There is a hole in the middle ,not sure where this fits if it is a stopper or what I will replace the printer. There are so many on sale now, I'm not going to waste ...
...drive where you can see the harddrive screw which is on a metal track stopped by a green plastic stopper. 7) Lift the green plastic stopper and push the back of the hard drive to the front of the ...
printer will not print- toner light is on- cartridge has been changed. have u removed all of the little stopper that comes with the new catridge ?
My c309 paper extender end piece won't stay attached.... you might need a new one... http://www.shapeways.com/model/961357/hp-paper-stopper.html
Question about Officejet Pro L7680 All-In-One Printer
The stack stopper on my HP L7680 All-in-One printer came off. How does it go back on? The stack stopper on the ADF of my HP L7680 All-in-One printer came off. I cannot find a picture online that is ...
...have tinkered with its not worth the headache Have looked again at the plotter and saw the Carriage Stopper was broke. I installed a new one and now it works. The Scan Axis Calibration was also ...
Usually answered in minutes!
2,817 Questions
2,162 Questions
1,869 Questions
1,584 Questions
1,504 Questions