Questions & Answers for: Watts stop switch

...a Onan Emeral 4000 watt generator. It only runs if I hold the start button, when I release it she stops. I have plenty of oil in it and when I disconnect the oil pressure switch and use a Ohm meter ...

...will not run there should be a fuse at the housing by the start/stop switch. if deisel then take the 10mm screw out of the coolant cap cover and check those fuses. verify power after. good

stop button on the generator. The inside switch appears to be working properly. Could the switch be wired wrong?/ Either you have a kill wire ( if I remember it is the brown wire) that is disconnected

...stop cycles and/or tapping on the oil pressure switch will sometimes fix it. It may be necessary to temporarily jumper the switch to ground to keep the engine running. This can be done at the switch ...

...in the middle (self holding) position. Lower position is to stop the generator. If left in middle position it is not running you may have the switch bad, or the generator is stopped by low oil

stop it. The switch may have lost its middle stable position and drop directly to stop. Try after you have the switch up for starting, let it easy back in middle position. If there it stops again. Try

...stop" level and after some time the precipitated oil has reached the "start" level. The same may be with oil viscosity and oil pressure. Try to add some oil or change the oil with bigger viscosity. ...

...stop switch down for several seconds to clear codes (haven't tried that yet) - but several readers say that doesn't work either. How can I clear the fault code to see if problem (fault 15) is still ...

...generator where does the wire that comes off the kill switch connect to A kill switch wire works by stopping power to the switch by connecting to ground..usually the engine..but any unpainted surface ...