Questions & Answers for: Suzuki stop switch

...Which switch? Kill/ign switch? All switches should ohm out to 0. Pure continuity. Cheap meters will read 1.2-1.6 and jump around a lot. Water in the Stop-Run-Stop kill switch is a notorious

Ad

Engine stops running as if turned off by a switch. Turns over very easily but will not restart. When it does start, it only runs for short period of time then stops again. Seems as if it may be the ...

Ad

Question about 2007 GSX-R 600

1 Answer

...going on. Any suggestions? I suspect the side stand switch is not connected. The switch stops the ignition from working as a safety measure; to stop the rider from riding away with the stand

Question about 2007 Grand Vitara 4WD

1 Answer

...switch to shift into "4L LOCK". From 4L LOCK to 4H LOCK Stop the vehicle completely, place the transmission in "N" (Neutral) and depress the brake pedal and the clutch pedal fully (if equipped), then ...

Question about 2003 RM 125

1 Answer

how to start it. Turn the run/stop switch to stop, choke the engine and give a couple of sharp kicks then turn the switch to run and it should start in a kick or two.

Question about 2007 Grand Vitara 4WD

1 Answer

...LIGHT BLINKS LIKE IT IS TRYING TO You can operate the transfer switch either when the vehicle is stopped or while the vehicle is moving. I always operate the switch while stopped. Put the shift ...

Question about 1998 GSX-R 600

1 Answer

voltage to all ignition components you mentioned originates from the engine stop switch. All orange white wires should be hot with key and stop switch on. Trace as necessary to find where the break is

Question about 2005 Eiger Automatic 400 4X4 Camouflage

1 Answer

...not start but will spin over.i have checked the fuses and connections all are ok.could the relay switch be the problem? Make sure you didn't accidentally move the Run/Stop switch to the Stop

Question about 2007 Forenza Sedan

1 Answer

2007 sazuki forenzo windows wont stop power windows wont stop engaging If you mean they wont stop accutating, you may a a bad switch, or maybe the switch got wet.

Question about 1995 VS 1400 Intruder

1 Answer

turn signal & horn problem my turn signals and horn all of a sudden stopped stopped working!?? fuses or grounding. If these are ok check for broken wire to handlebar switch or switch problem.

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Suzuki Experts

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Sean Wright
Sean Wright

Level 3 Expert

2045 Answers

Bob G

Level 2 Expert

104 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...