Questions & Answers for: Husqvarna stop switch

Ad

Question about "Chain Saw - 16" Bar, 3 Hp

1 Answer

Stop switch The stop switch broke off on my Husqvarna 36/41, 16'' bar and I need to know where the hookup is one end of the blue wire goes to the ignition coil and the other end goes to the stop ...

Ad

Question about "Chain Saw - 16" Bar, 3 Hp

1 Answer

...stop button is just an on off switch or a monitary off(Short) switch which shorts out the primary to the coil. Either the switch is broken , the ground wire not making good ground or the primary wire ...

Ad

...stop as soon as I release the switch. The PTO switch has failed. There is an internal spring and plastic parts in toggle switches that keep them in the actuated position. It's not practical to take ...

Question about 23 Hp 48" Deck Yard Tractor

1 Answer

stop switch doesnt seem to work. I push the switch to stop and the saw continues to run. The only way to kill it is to use the choke. Is the kill switch bad? Thanks a lot. Hi Yeah,your switch has gone

Question about 23 Hp 48" Deck Yard Tractor

1 Answer

...stop switch (check for continuity with a multimeter), one of the leads has become detached from the switch or is broken, or the lead from the switch to the chassis of the saw has gone open circuit. ...

Question about 23 Hp 48" Deck Yard Tractor

1 Answer

stop switch won't stay in choke I just bought a refurbed Husqvarna 445. I got the bar and chain on, filled up with gas and oil, but I cannot get the start stop switch to stay in the choke position

...switch is placed in the stop position it touches the wire from the unit to the earth strip and stops the engine, make sure the wire has not come adrift from the side of the switch, if not check both ...

switch down to stop it, it doesn't. I removed the cover and a saw a wire (female connection)disconnected, but I don't see where thi Hi, I have a Husqvarna chain saw 345e EPAII. When i push the

Question about 23 Hp 48" Deck Yard Tractor

1 Answer

On the other hand the nut underneath it does spin. it does squeel a little when you start and stop the switch First of all check everything is in place and al the nuts are tight. Then replace the belt

...nuisance. Is this e Continuously pressing the stop switch and also rotating the trimmer to try and starve the motor of petrol (to prevent gravity feed from the tank. Obviously the switch is ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Husqvarna Garden Experts

J. Bradshaw

Level 2 Expert

121 Answers

Marvin
Marvin

Level 3 Expert

85216 Answers

dannydoesita

Level 3 Expert

771 Answers

Are you a Husqvarna Garden Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...