Questions & Answers for: Chevrolet stop switch

Question about Chevrolet

1 Answer

...Stop Lamp Switch Removal & Installation To Remove: Disconnect battery negative cable. Disarm the air bag system. Using snap ring pliers, remove pushrod retainer from brake pedal pin. Remove stop ...

Ad

Question about 1995 Blazer

1 Answer

...stop switch but no brake lights, put new stop switch in . also tail lights work and so dose turn signals if the brake switch has b+ on the orange wire and b+ on the white wire when you push on the ...

Ad

...signal /multfunction switch on the steering column.When it is doing this try wiggling the turn signal switch and see if it stops. If it does stop the issue is most likely in the turn signal

Question about 2006 Cobalt

1 Answer

...stop lamp switch controls the on/off function of the stop lamps including the center high-mounted stop lamp( CHMSL). The stop lamp switch get its power from the Body Control Module (BCM). This power ...

...stop light switch had\s a ORANGE wire that should have 12V if not ck STOP LPS fuse, when brake pedal is depressed, the WHITE wire is 12V (at the stop light switch) if that is OK, the turn signal ...

...stop lamp switch. When the driver presses the brake pedal, the switch contacts close and battery positive voltage is supplied to the center mounted stop lamp (CHMSL) and both left and right stop lamp ...

Question about 2006 Silverado 1500 2WD

2 Answers

stop lamp switch. When the driver presses the brake pedal, the switch contacts close and battery positive voltage is supplied to both the STOP 15-amp fuse and the center high mounted stop lamp (CHMSL)

Question about 2002 TrailBlazer

1 Answer

stop lamp switch. When the driver presses the brake pedal, the switch contacts close and battery positive voltage is supplied to both the VEHICLE STOP fuse and the VEHICLE CHMSL fuse. The current flow

Question about 2005 Chevrolet Avalanche 1500 LS

1 Answer

...stop lamp switch. When the driver presses the brake pedal, the switch contacts close and battery positive voltage is supplied to both the STOP 15 A fuse and the CHMSL 10 A fuse in the I/P fuse block, ...

...stop lamp switch signal circuit is a normally open switch. When the brake pedal is released, the engine control module (ECM) detects a high voltage signal on the torque converter clutch (TCC) brake ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Chevrolet Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...