Questions & Answers for: stop clothing twisting front load

Question about WM-2277HW Front Load Washer

2 Answers

stop the leaking. OR- intermittent leaking can be caused by a suds-lock forcing a little water out the stand-pipe. It is a good idea to start the washer with no clothing (in the washer) to see if suds

Ad

stop the washer and it takes a while for the door to unlock and when it does I see a shirt twisted and tangled with the rubber seal of the door and its totally torned and worthless. Is there anyway to

Ad

...clothing is stopped mid cycle with the F-21 blinking, blinking and all the lights in the left panel of the washer blinking. This happened about an hour ago and I reset the washer and put the "sopping ...

Question about Duet GHW9150P Front Load Washer

1 Answer

load to unlock the door. My clothes are sitting in water, and I cannot get to them! What the heck is F O2 error? Drain out water thru front panel, will find hose there. Press & hold 'end of cycle' for

Question about HE2 Plus Front Load Washer

1 Answer

...to clean. Next run your washer with 2 cups of bleach, hot water. After it starts agitating stop the washer & let it remain for 2 hours. Then continue the wash. Try using powders for 'front

Question about Duet GHW9150P Front Load Washer

2 Answers

...Washer stinks smells musty like maybe water is not draining properly My pant legs and long sleve shirts twist into a knot, every time. How can I stop this from happening? Most likely bad ...

Question about Duet GHW9150P Front Load Washer

1 Answer

load in my 9150 (barely one year old), and either goes to F35 or to SUD, then F35. Have to shut breaker off to get it to stop! This happens 90% of the time! Serviceman came out and said I needed a new

Question about Duet GHW9150P Front Load Washer

1 Answer

washer is in rinse cycle but stopped working. full of wet clothes and water in tub. don't know what to do Sounds like the lint catch basket, located with the drain pump is clogged with lint, debris or

Question about Duet GHW9150P Front Load Washer

2 Answers

...stop it is to unplug it. There is a small access panel on the bottom of these newer Maytag and Whirlpool washers. Three small quarter inch screws hold the panel in place. Once the screws are removed ...

front load washer. It worked fine then one day went to put clothes in dryer and they were extremely wet so put them through the drain/spin cycle. Put another load in and there was water in the basket.

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Washing Machines Experts

Brad Brown

Level 3 Expert

19187 Answers

Cindy Wells

Level 3 Expert

6688 Answers

john h

Level 3 Expert

29494 Answers

Are you a Washing Machines Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...