...bad convergence chips, part number stk 392-570, or stk 393-110, you also have one or 2 blown 5 amp pico fuses, common repair, but you could not do it yourself unless you are a qualified tv
...392-570, or stk 393-110, the tv needs to be taken apart and the chips have to be soldered in, a qualified tv repairman could do it, but a consumer could not, and would probably damage the set
Question about WS-55511 55" Rear Projection Television
...not turn on. Any idea what the problem could be? hi the problem you have is your convergence ic outputs part #stk 393-110 ther located on the front of tv chek for burning resistors on the same ...
Question about WS-55511 55" Rear Projection Television
...time. Sunny See my reply to your last posting---The set needs The Stk-393-110 and whichever of the two pico fuses is blown replaced--I have instructions AND photos of what the fuses look like. SD ...
Question about WS-55511 55" Rear Projection Television
...STK-393-110" convergence IC Chip. you must have a toshiba tv. easy. with the back off, you will see 2 convergence ic's mounted on big silver heat sinks. and they will say on them stk-393-110. replace ...
Question about WD-52525 52" Rear Projection HDTV
...STK-393-110 it is not a WD52525. What is exact model number on back of set? Mitsubishi sets using the part are rear projection sets-- I have START TO FINISH, STEP BY STEP INSTRUCTIONS FOR REPLACING ...
...stk 393-110, if u have same electronics skill this would be same projec for u but u also have the option to take the board out and take it to a repair shop , probably u going to pay $50 for labor , ...
...STK-393-110. You will need to order an after market market convergence IC (STK 393-110) I have had good luck with this IC. Next, check and replace all the 3.9 ohm 2 watt resistors, that are bad. You ...
Question about WS-73909 73" Rear Projection Television
...STK-393-110 CHIP IN SETS THAT USE IT--available here for free if you need them. please let me have the info for my mitsubi. ws-7390 I have START TO FINISH, STEP BY STEP INSTRUCTIONS FOR REPLACING THE ...
IC8C01 INSTALL HOW DO I INSTALL IC8C01 Convergence chip! It should be a STK-393-110 CHIP.Is it located on the middle board or the side board?
Usually answered in minutes!
2,410 Questions
2,254 Questions
1,646 Questions
1,423 Questions
1,438 Questions