Questions & Answers for: Mitsubishi stk 392 040

...IC's are on the left of the TV, looking from back, the TV uses STK 392-040 (two) convergence IC's. They will be mounted on a large heat sink (large silver/metal) looking device. Good Luck, big

Convergence Can't convergence blue to yellow wont move. Replace both of your STKs big black ics 392-110s Go by number on STKs392-560or STK392-570 ,392-040 ect........

...bad convergence chips, part number stk 392-570, or stk 393-110, you also have one or 2 blown 5 amp pico fuses, common repair, but you could not do it yourself unless you are a qualified tv

...STK-392-110--IT USES TWO STK-392-570 CHIPS. IF WHATEVER SET YOU HAVE USES A STK-392-110 YOU CAN USE THE STK-392-150 TO REPLACE IT--it is a higher current device than the 110 chip---there are some ...

...stk-392-570 convergence chips has failed. I will attach a photo---they are on the middle circuit board and the two to the right are for convergence--both are green and 5 amp--with the set unplugged ...

...stk 392-570 to stk 392-560 is that ok ? I would definitely stay with the original stock number. Always a good rule, unless an authorized repair is warranted. As for resistor replacement any philips, ...

...STK-392-040 CONVERGENCE chips need to be replaced and the set adjusted. One is bad for sure and it is best to change both. Parts cost is under 30 total for this and it may be a do it yourself job if ...

stk 392-570 or stk 393-110, if u have same electronics skill this would be same projec for u but u also have the option to take the board out and take it to a repair shop , probably u going to pay $50

...STK-393-100 or a pair of STK-392-570's the only way to tell is to look inside. unplug the unit and take off the back. the convergence chip(s) is on the center board on the big finned heat

stk part number for vs-7083 model not listed--sure it is not a VS-70803?That model uses the 392-040 chips and for that matter you can look inside to confirm the number right on the chips.