...shift solenoid has either one gone bad or two the wire harness going to it has an issue. are there any check engine lights on, if so have those been recovered and diagnosed yet? does the vehicle do ...
...the reverse or parked position. Simply replacing this shift lever solenoid will fix this issue. You can expose the solenoid by disassembling the shift stick housing, Please rate and have a great
...stick shift wont go into reverse.like there is something blocking it.what can it be I would first look into the shift cable bushings and make sure that they are not worn out, cracked or missing. Make ...
...stick shift wont go into any gears, it only moves forward and backwards. this happened when the stick was being moved into reverse. what happened to my stick shift? it sounds like the shift linkage ...
Question about 2007 Uplander LS Minivan
...shift out of reverse and wont start now Started the car up, then put it in reverse. When I stopped to put it in drive it would not budge. I turned the car off and I still couldn't shift the ...
Question about 2000 Accent
...wont run i check both the old and new pump with a 12v battery they work !! checked the pl wiring issue washer/ fluid issue / reverse light sometimes stay on the switch is burnt out. get one from a ...
...Shift into reverse? If its a 5 speed stick its usually to right and down. If it is an automatic its the R directly under the P. If it is in and still wont go into reverse you need a
stick shift With the engine off, can you put it in reverse? Can you put the clutch in and keep it in reverse, then start it, and it moves back? If you can, but can't get it into reverse again with the
Question about 2000 Accent
...MOVE. (IN ALL GEARS? even in reverse) CANT START ENGINE IN GEAR? (STICK) cant shift by hand. cant shift gears with out grinding ? (stick) transmission fails to shift up or down(auto) engine runs
Question about 2000 Accent
...shift stick alignment revs out more likely a solenoid or mechanical failure if there is a bang as you shift into reverse its the oil pump if none of the above are the cause could be the module ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions