Questions & Answers for: status lamp

Ad

Question about HC900U Multimedia Projector

1 Answer

...lamp or what? Thanks. your projector status means the protection circuit is working or the lamp is in an abnormal condition. --wait until status indicator goes out and press power button. ---if the ...

Ad

Question about VT670 Multimedia Projector

1 Answer

...lamp The status indicator lamp blinks it's 6 sec cycle. As described in the manual, this indicates Lamp Error. When we try the troubleshooting suggestion of waiting one minute and turning it back on, ...

Ad

Question about WD62527 62 in. LCD HDTV

1 Answer

...does it say anything about a slow blinking green lamp indicator, much less both the lamp and status indicators blinking at the same time (green and yellow). What can I do? Lamp is bad need new ...

Question about VT47 Multimedia Projector

2 Answers

...lamp indicator goes out. Same blinking status light. I replaced the bulb and tried again, same blinking status light. I checked the filter, etc. This projector has not run for 2100 hours, so the bulb ...

Question about WD-62525 62" Rear Projection HDTV

1 Answer

Status Light Flashes Red Repaced lamp 2 weeks ago everything went fine. Last night fell asleep watching I woke up an the set was off and the status indicator is flashing red. I turnern power off at ...

Question about WD-62525 62" Rear Projection HDTV

1 Answer

lamp status" for Mitsubishi wd62725 I just replaced my lamp and yellow light is still on. Owner's manual says "lamp status" reset instructions are on page 63, but no information re "lamp status" reset

Question about XD300U Multimedia Projector

1 Answer

...lamp status lights Mitsubishi XD 300 U won't project, power light blinking red/green, and lamp status light blinking also,, what do I do to make this thing go? ...replace the lamp. The lamp is most ...

Question about VT465 Multimedia Projector

1 Answer

...status light and no lamp The projector will turn on and the start up process is normal until the light should turn on. Then status light which started out green begins to flash red. The lamp does not ...

Question about WD-62825 62" Rear Projection HDTV

1 Answer

...out (indicator goes to constant red status). Replace lamp (get lamp P/N from User Manual for replacement), clean any dirt around lamp, fan, and rear filter. Do NOT get any fingerprints on new

Question about WD-62825 62" Rear Projection HDTV

2 Answers

Status 3) Lamp If "STATUS" LED is blinking RED: 1) Internal Fan has stopped. These tv's require fans, to prevent overheating and causing damage. If "STATUS" LED is solid RED: 1) Circuit failure (short

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Office Equipment & Supplies Experts

jasbo
jasbo

Level 3 Expert

2239 Answers

Ekse

Level 3 Expert

13434 Answers

Marvin
Marvin

Level 3 Expert

85219 Answers

Are you an Office Equipment & Supplies Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...