status indicator blinking red When I switch on the projector, the status light first blinks green a few times, then a beep beep beep is heard and the status indicator starts blinking red, 5 cycle: the
button the the unit is in off status, and then press the red button (power button.) After you push and release the red button, release the number eight (8) button in about 1 to 2 seconds later. Method
Question about HL 5140 Laser Printer
...button. Clean drum unit - Clean the corona wire. Help me, please . Red status light on. PC recognises printer. Nothing happening. Toner was on for a few weeks. But now new toner cartridge and still ...
...button for 10 seconds (to try and reset) the status light turns red while I'm holding the button in, but as soon as I let off it turns yellow again. Likewise if I try to push and hold the open/close ...
...button!!! Water Filter Status Indicator Light (select models) The Water Filter Status Indicator Light serves as a reminder to replace the water filter. A green light indicates that the filter is in ...
Question about MZD2665HE Side by Side Refrigerator
red light stays on after changing the water filter and running about 2 gallons through it Water Filter Status Indicator Light (select models) The Water Filter Status Indicator Light serves as a ...
...status. 5. Press and release the ?OK? button 6. Display should say ?Hardware failure status: Clear. Press OK to clear?. 7. Press and release the ?OK? Button. Message changes to ?Hardware failure ...
Question about KBFA25ER Bottom Freezer French Door Refrigerator
button for 3 seconds. The status light will change from red to green or the status display will change from "Replace" to "Good" when the system is reset.If your model has a water filter indicator
Question about Torsten Soundbar with 10" Wireless Subwoofer
...button on the SoundBar until the status light is solid GREEN. STEP ONE (Place the unit in learning mode): With the status light showing solid GREEN, press and hold the <SOURCE> and <MUTE> ...
Question about Torsten Soundbar with 10" Wireless Subwoofer
NEC NP-M300W projector: Lamp status RED, replaced lamp still RED. Status indicator GREEN. Won't power on. On the remote control of the projector, press and hold the HELP button for 10 seconds.
Usually answered in minutes!
2,817 Questions
2,244 Questions
2,162 Questions
2,149 Questions
1,912 Questions