Questions & Answers for: stator specs Lands Phones

bike runs ok untill hot, spark weak.. ..tested coil,stator, neutral switch etc...all in spec to manual I would still replace the stator.

specs are 90-120 volts ac. I am getting 47 the fact that you only get 47 volts indicates the stator has an open, there is nothing else but the stator that causes this low un-regulated voltage reading,

...the brush block because it was bad with no help. I took resistance readings of the rotor and stator. Are these in spec?? briggs and stratton model 09719-3 with a generac 5000 watt generator ...

...but the coil what could it be. you need to use multi meter to test resistance readings from the stator your owner manual or bike shop can tell you what readings are within spec for each source on ...

...cause this? if no improvement then I would get a multi meter and test resistance readings on your stator connection leads and also check resistance on your ignition coil pack - Your service manual ...

...good and set correctly but no sign of life when trying to start 99% of the time ends up being the stator. And I know it seems strange but I honestly up to about my tenth bike now where even though ...

...stator, all 3 are connected to each other. I f you don't have the ohm specs just check for resistance with an ohm meter. All 3 should show continuity to each other no matter what order you test. And, ...

I have a 1971 Suzuki t350 bad stator Ideas? bad stator Being a resistive coil there are pass/fail values for that assy. Given it's age, a re-wound unit will restore functionality if that is in fact ...

Torque spec for stator bolt on 1982 Honda cm450e This information may be in the site already. May help but for 92 year spec's. Check the following link: Head torque specs for 92 honda accord with ...

...tell you. If you're going that deep into the bike, you should really have one.

Added info:

Yo Bruh... The torque specs for my Yamaha Vstar stator are 5.1 FT ...