Questions & Answers for: Yamaha YZF 600 R thunder cat stator specs

IT WONT FIRE AT THE SPARK PLUGS,ITS A 2004 YZF 600R Check the CDI , the stator,and coil for power,If you have power at the stator but not the coil,The CDI is bad,If you have power at the coil but not ...

...to the battery could be caused by: faulty / loose / corroded / burned terminals / connectors from stator to regulator (most likely); faulty rectifier / regulator combo (likely); faulty stator

...multimeter should read 0.1 to 0.2 OHM'S. If you are not getting these numbers, you have a bad stator. 7. Check all wiring in the charging circuit for worn or chaffed spots and all wiring ...

what are the torque spec. for cam bolts on a 95 yzf 600 Hi, Temps_up for this scenario you will need your service/owners manual if you can't find the first and best tool you ever bought for your ...

what are the torque specs for the 8 bolts on the cylinder head on a 96 yzf 600 Hi, Karson_moffe for this scenario you will need your service/owners manual if you can't find the first and best tool you

what is the torque spec on the front sprocket on a 1999 yzf600R? Hello, If you are referring to the Drive Sprocket the torque is 43 ft-lbs (according to the service manual). Regards, Oz

...multimeter should read 0.1 to 0.2 OHM'S. If you are not getting these numbers, you have a bad stator. 7. Check all wiring in the charging circuit for worn or chaffed spots and all wiring ...

Yamaha Thundercat 600 front axle torque spec what are the torque settings for a front wheel on a yamaha thundercat 600 motorcycle Hi, Anonymous for this scenario you will need your service/owners ...

...Specs: 22 amp system produces about 0.2 to 0.4 ohms 32 amp system produces about 0.1 to 0.2 ohms 45 amp system produces about 0.1 to 0.2 ohms Stator IB test or Ground Check: Switch your multimeter to ...

i have a 95 yzf 600r i replaced the stator rectifier and battery and it still wont charge Hi, Anonymous you may have a faulty rotor for this scenario you will need your service/owners manual if you ...