Questions & Answers for: Harley Davidson FXDBI Street Bob stator specs

...regulator,am wondering if there is a common problem in wiring harness somewhere Check the connector stator/voltage regulator, check for worn wires alnog the frame at the 5 cable ties/clips. Check ...

why is my 2006 street bob not charging stator tests out I just replaced voltage regulator dont seem to be getting proper voltage coming out or charging volts at battery If the regulator was replaced ...

replacing Exaust What is the torque specs for an 06 Harley Street Bob exaust flange bolt? tight. use small amount of blue lock tight on threads.

...stator/regulater problem.Check the condition of each one with multimeter.Factory specs in shop manual.Could be ign switch but that's a stretch.Check alt with bike running for better results.Oh ...

...2000 rpm. are there aftermarket voltage regulators that will work with the variable output the stator puts out or do I have to pay the 150 bucks for a factory voltage regulator? As far as I

bearing behind the stator on the primary case.Harley said that the screws in the bearing sear off and you have to have the bearing pinned.Looking for a solution to correct this. That kind/type of ...

transmission is making a rubbing sound on start-up. Runs quite in neutral with clutch handle pulled. As soon as I put it in gear and release clutch It starts grinding. Fluid is at correct level. Any ...

what is the dynamic output for a stator? Hi Brandon, Battery Sealed, maintenance-free, 12V, 19-amp/hour, 270 cca (per Battery Council International Rating) Charging Single-phase, 45-amp system (559W @

wont hold charge both engine and battery light come on Check the stator and voltage regulator. One, or both are probably defective.

... With ohm meter, one lead grounded, touch alternator pin meter should read infinity, if not replace stator. 9. With ohm meter, both leads touching alternator pins meter should read 0.1 to 0.2 ohms on ...