change a stator How do you change a stator on a 2003 harley dyna super glide FXD? First secure the bike on a lift. disconnect battery.remove standard footpeg.Remove standard shifter. Remove all allen ...
...getting the proper charging rates the one possibility is that the connection where the alternator stator wires plug into the regulator could be corroded/dirty and need to be cleaned and sprayed
03 road king stator replacement What gasket, and seals are required to change stator u need to open up the primary to do it. as far as gaskets, just new one for between the inner and outer primary....
I load tested the battery, it was only putting out 12.51 volts at all RPM levels. I then tested the stator and the Ohm test proved ok at 3.0, but when I did the AC test it was only putting out 3 volts
2002 fxd stator to perform the stator test, the wires coming from the voltage reg through the plug connecter to the block. is the block connecter a plug in connection? or hard wired? can't ...
change a stator on revtek 100 this is a custom harley with a Revteck 100" motor w/ an open primary and need to change the stator Hi Anonymous, for more information on your question please visit the ...
stator wire connections You should replace the stator.
...stator. If this is required, replace all the seals in the inner primary while you have it off. A service manual will be a great help if you do this job yourself. Torque specs are rather high for ...
...specs you are looking for for the outputs etc. But if you have changed everything you say you have and checked out the wiring and connections that leaves the stator which is part of the alternator. ...
...operate the starter and other electrical systems of the bike. The connection where the alternator stator wires plug into the regulator could be corroded/dirty and need to be cleaned and sprayed
Usually answered in minutes!
137 Questions
126 Questions
109 Questions
61 Questions
45 Questions