Questions & Answers for: Briggs & Stratton stator specs

...Have the same generator. Shows only 3 Volts. I took the generator apart and found that the stator winding was burned. Can buy a replacement stator for about

how much volts should my stator put out on (18 h.p. briggs intek) If it is the two yellow wire stator it should put out at least 28 ac volts across the two yellow wires, if it is a single red wire it ...

...the brush block because it was bad with no help. I took resistance readings of the rotor and stator. Are these in spec?? briggs and stratton model 09719-3 with a generac 5000 watt generator ...

Stator wires on 13HP B&S Noma lawn tractor D3912-090 with Briggs and Stratton I/C Quiet engine 281707-0130-01, code 891023. Previous owner cut off wires of the stator - there are 2 wires hanging ...

...this be a problem with the charging system? yes it could be check your battery 1st , then check the stator a/c output ? 10 or 16 Amps DC regulated for charging battery ? Two black leads (C) from ...

...8000 watt. We started it up two weeks ago and smoke came from every wear. Took apart and the stator winging we burnt. Have new stator in and everything is hooked up and nothing is being ...

need a stator for my 24 HP briggs and stratton motor INTEC OHV engine model number is: 445677-0413-E1 has 3 wires connecting to stator from electronic ignition two black and one red ebay is the ...

...will not have the proper grounding to function. Underneath the flywheel is a device called an stator. This stator creates an alternating current or commonly called A/C Voltage. This voltage ...

up removing flywheel and noticed magnets on inside of the flywheel had come loose and crashed in to stator coil causing unit to ground out immediately when key turned on. I reglued magnets to flywheel

how to test portable generator stator for short in windings Briggs & Stratton 6250 watt portable generator Family 3BSXS. 3422 HT 275385 You will need what the factory resistances valuea re supposed to