Questions & Answers for: Harley Davidson FXSTD Softail Deuce starter bolts

Question about 2003 FXSTD Softail Deuce

2 Answers

Do I need to remove the rear tire on my 2003 harley davidson softail deuce to replace the brakes? You do not have to remove the wheel according to the manual, but if you wish to remove the caliper you

Ad

Question about 2003 FXSTD Softail Deuce

2 Answers

Quick check of the clutch adjustment. Put the bike in low gear and pull in the clutch. Now hit the starter button. If the bike surges forward before it starts up, you need to adjust the clutch. Also,

Ad

Question about 2003 FXSTD Softail Deuce

1 Answer

how do I remove the battery from my 2003 soft tail classic? Remove the seat, disconnect the rubber "hold down' strap, disconnect the wires and lift the battery out. Earlier model softails had a bolt ...

Question about 2003 FXSTD Softail Deuce

2 Answers

...bolts off starter put new starter on the same way Drain primary oil and remove outer primary cover, Remove starter Jack shaft bolt. now on starter side of primary remove the two allen bolts that bolt ...

Question about 2003 FXSTD Softail Deuce

1 Answer

.....13.7 bike running.. check at battery conections ...Make sure conections clean at bat & at starter ground & pos. bolt on starter has been known to come loos check ground to frame ...

Question about 2007 FXSTD Softail Deuce

1 Answer

...Output Short to Battery. B1131 Alarm Output Low TSM/TSSM B1132 Alarm Output High TSM/TSSM B1134 Starter Output High TSM/TSSM B1135 Accelerometer Fault TSM/TSSM B1141 Ignition switch

Question about 2003 FXSTD Softail Deuce

1 Answer

...starter mounting bolts and washers Slide back the rubber boot, remove the nut and disconnect the positive cable from the starter terminal. Note the location of the circuit breaker cable terminal ring ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...