Questions & Answers for: Saturn SL starter bolts

...bolts holding the starter. One bolt is almost inaccessible. I used a 13mm deep well socket and a couple of different length extensions (one 4" and one 2") to reach the two different bolts and remove ...

...bolts. One bolt is visible on the bottom of the starter, the other you will have to feel around behind the starter for. The first step in this job is to disconnect the battery, that way when you ...

...the starter is located need to know where the starter is located on my 2000 saturn wagon sl1 Located on rear of block.2 13mm bolts attach starter to block.Top bolt is not fun to reach on the

93 saturn twin cam starter removal i have a 93 saturn twin cam four door, im trying to remove the starter and have the bottom bolt off but cannot locate the top bolt manuel says the bolt must be ...

...starter mounting bolts. It may be necessary to raise or lower the vehicle for access to both the upper and lower bolts, but do not tighten any bolts until all of the mounting bolts have been started. ...

...you have to 13mm bolts that hold the starter to the engine,remove the top bolt first you cant see it but you can feel it,,,then remove the bottom one and the starter will fall out and thats ...

...Next put socket on bolt with breaker bar and wedge bar some where solid on car. Bump motor with starter the small r turning of the starter will loosen ...

...Pictures would be helpful to the back of your engine is the old starter.. Unbolt it (remember where the bolts are.. 2 the side of it.. Remove wires and connect it to new one.. Bolt starter back

is a ***** to replace, in case you are considering that. Access to starter and mounting bolts are the problem. Like every starter I have ever seen it has just two bolts, and the electrical connections

...bolts holding it to the engine block, one of them is a Blind bolt, as you will only be able to feel its location on the back side of the starter. (tip, when replacing the bolt behind the starter, ...