Questions & Answers for: Nissan Altima starter bolts

...wiring from starter. Remove starter retaining bolts and the starter. Reverse procedure to install. the bolts should be on the drivers side. you will have to crawl underneath the car to do this ...

Ad

Question about 2002 Altima

1 Answer

...starter mounting bolts and remove all but one. Support the starter while removing the remaining bolt. Then pull the starter out and away from the flywheel. Once the starter is free, remove the last ...

Ad

...bolts from starter housing. They are long bolts that pass through the starter housing into the engine block. Starter drops down, so don't let it hit you in the face. Installation is just the reverse ...

starter mounting bolts. Carefully lower the starter from the vehicle. To install: Position the starter on the engine and support it using a jackstand. Install the starter mounting bolts and tighten to

Question about 1995 Altima

1 Answer

...bolts that bolt the starter to the engine. Remove them. Might also be the same size but I doubt it. Best to use a socket if you can get one in. Take the starter out ... insert the rebuilt starter, ...

...bolts for the starter are hidden on the right side of the engine block just slightly left of your throttle body. once you remove all your plastic hoses for the air filter and such, you should be able ...

Question about 1995 Altima

1 Answer

...starter bolts and push it away / reposition it farther from the flywheel (circumference) then retighten the bolts. Then try it again. It is rare that a rebuilt starter is defective but... it does ...

...bolts Starter from the vehicle Fig. Starter location and mounting detail-3.0L Maxima with a manual transaxle Fig. Starter location and mounting detail-3.5L Maxima To install: Install or connect the ...

...Starter bolts Starter To install: Install or connect the following: Starter Starter bolts. Tighten the bolts to 30?37 ft. lbs. (40?50 Nm). Harness connector Connector bracket to the front mount ...

Question about 2000 Altima

1 Answer

...starter is. It's bolted on, with two bolts, where the transmission bolts to the engine, at the back end of the engine.Just remove the two bolts, remove the electrical connections to the starter ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

2005 Nissan Altima
2005 Nissan Altima

1,587 Questions

2003 Nissan Altima
2003 Nissan Altima

1,450 Questions

2002 Nissan Altima
2002 Nissan Altima

1,306 Questions

2001 Nissan Altima
2001 Nissan Altima

569 Questions

1995 Nissan Altima
1995 Nissan Altima

534 Questions

Manuals & User Guides

Loading...