where is the starter? bolted too the bellhousing underneath
bolts on the back side of the starter, be careful the small heat shield around the starter will come loose, pull it out toward the back, there will be a gap between the axle and the sway bar. When you
What size are the starter bolts? 17mm spanner size if i remember rightly 13 mm the last 15 i changed...
My starter has gone out and it is parked in a fire zone at the grocery store. My Mother was using it at the time. I need to know what it looks like and how to replace it. I am an unemployed full-time ...
...Starter motor and cover. Torque the bolts to 20-25 ft. lbs. (26-33 Nm). Wires Front engine mount heat protector. Torque the nut to 89 inch lbs. (10 Nm). Engine under cover, if equipped Negative ...
...quot;Start". Car stopped while driving. Towed home. This sounds like a loose connection at the starter, Follow the positive battery cable down to the starter. Check the connection for being hot ...
Question about 1998 Montero Sport
...starter in my 2001 mitsubishi montero sport. where are both bolts? There is one on the bottom and one on the top.The one on top is next to the starter solenoid. It's there you just need to ...
Question about 1999 Montero Sport
...starter bolts due to exhaust heat shield. BUT CUT off the top ring/bolt hole on heat shield PLUS a little extra about 1/2 inch deep from ring side into the mass of the shield... ...
...STARTER ITSELF FOR LOOSE CONNECTIONS OR MOUNTING BOLTS. Simple stuff first. Check battery for being bad, Take it to auto store where they have a real battery under load tester. Advance auto normally ...
Question about 2001 Montero Sport 4WD
...engine bay to reach the sensor, including the air intake duct, battery and battery tray, and the starter motor. Here are the steps to replace the crank position sensor on your 2001 Mitsubishi ...
Usually answered in minutes!
593 Questions
427 Questions
263 Questions
124 Questions
6 Questions