Valve cover torque!! What is the specific torque that i need to apply to tighten these bolts down. hand tighten then torque to ~ 50lbs in. in an alternation method. Meaning tighten one bolt then go to
AUTO PROBLEM AS LONG AS YOU ARE SPRAYING STARTER FLUID IN THE INTAKE IT WILL START WHEN YOU STOP IT SHUTS OFF check the fuel pump....you are not getting fuel.good thinking with the starter ...
...bolts holding the starter to the tranny. At least one of these bolts is accessed from above the transmission, requiring the removal of (at least)the air filter housing and intake, and the battery and ...
STARTER WONT ENGAGE ONLY CLICKS UNDER HOOD STATER STARTER WONT ENGAGE ONLY CLICKS UNDER HOOD STATER CHECKS OK BATTERY CHECKS OK REPLACED STARTER RELAY STILL NOTHING POSSSIBLE IGNITION SWITCH ? If the ...
location of starter on mazda 929 Starter is located on the passenger side, its mounted on the transmission.
...jump - nothing. Battery is good and I have all lights and everything. Had towed to my house. Is it starter or ? is the solenoid clicking? If not, you can't blame the starter. See my tips at ...
i need to replace the alternator belt on my 1992 mazda 929 Find The Alt. Loosen But Don't Remove All Nuts Bolts That Look Like They Might Be Holding It On. Disconnect The Neg Battery Cable From The ...
In what sequence do i tighten down the valve cover bolts? Always tighten bolts in a criss cross pattern. Other then that it will not matter. The jumping back and forth is what creates the greater seal
Is starter on 1988 mazda 929 hard to replace? It is a tight fit and may require that you take the motor mounts loose and raise the engine to access the starter. It is definately a job. Yes it is! ...
Question about 1992 929
I have a 1992 mazda 929 that will not roll over I checked the starter and its goodthe battery is fine all lights and radio work any ideas,? I'm at my wits end does it make any noise at all? if not get
Usually answered in minutes!
86 Questions
74 Questions
50 Questions
25 Questions
21 Questions