Questions & Answers for: Ford Expedition starter bolts

...bolts to remove starter You will need some tools that will give you enough reach to go over the top of the starter, and more than likely a swivel joint to get enough access to remove the bolts. They ...

Ad

...starter, there are 3 bolts. Clock positions of 1o'clock, 5o'clock, 9o'clock. 1o'clock bolt: is not to be seen being visually blocked by the solenoid. However with the proper length extension and ...

Ad

...bolts that hold the starter to the bell housing. Lube the bolts (must be clean too) - place the new starter... install the bolts... Torque to about 30 lbs .... the reconnect the wires to the new ...

Question about 1999 Expedition

1 Answer

...starter mounting bolts (typically only 2 bolts) 4. Install new starter. Hand tighten mounting bolts 5. Secure both bolts to about 35 Lbs of torque 6. Connect power cable. 7. Connect the negative ...

...bolts Starter motor from the vehicle To install: Install or connect the following: Starter motor and retaining bolts. Tighten the bolts to 15?20 ft. lbs. (20?27 Nm). Battery starter cable and a ...

starter retaining bolts-4.2L engine shown Fig. 5 Remove the two starter retaining bolts-4.6L engine shown, 5.4L and 6.8L engines similar Disconnect the negative battery cable. Raise and safely support

Question about 1998 Expedition

1 Answer

how take the starter off I had to remove one on a 4x4, if you have 2 wheel drive you have more room. Before you guess the starter is bad, there can be problems with the Main wiring to the starter. ...

...of the starter and you could fit your hand up there to feel it and place the socket. The 3rd bolt is between the bottom and top bolts. Remove the 3 bolts and the starter falls right out. All the

Question about 1997 Expedition

1 Answer

...and the starter motor to the block. Under neath just line up wich mount bolts are close to the starter and undo them, possibly 2 that hold them. once remove starter should fall straight into your ...

Question about 2001 Expedition

1 Answer

...bolts Starter motor from the vehicle To install: Install or connect the following: Starter motor and retaining bolts. Tighten the bolts to 15-20 ft. lbs. (20-27 Nm). Bttery starter cable and a ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

2000 Ford Expedition
2000 Ford Expedition

2,188 Questions

1999 Ford Expedition
1999 Ford Expedition

1,825 Questions

1998 Ford Expedition
1998 Ford Expedition

1,627 Questions

2003 Ford Expedition
2003 Ford Expedition

1,696 Questions

2001 Ford Expedition
2001 Ford Expedition

1,161 Questions

Manuals & User Guides

Loading...