Questions & Answers for: Chevrolet Suburban starter bolts

...bolts on the new starter to line up. What am I doing wrong? Hey donna88king, gotta love those starters :) actually I dont imagine you are doing anything wrong prvidind there is no thread damage, try ...

to the motor from underneath, has two bolts holding starter in, flywheel cover over part of the starter and held in with 6 or 8 bolts. it's against the motor behind the exhaust manifold/lead down pipe

...bolts Remove the starter from the vehicle REMOVAL & INSTALLATION (see Figures)The following is a general procedure for all trucks covered in this information, and may vary slightly depending on ...

how to remove and replace starter disconnect the battery then the 2 starter bolts on the starter and pull it off then put the new one on and replace the bolts and wires the reconnect the battery

...starter from my 2000 chevy suburban. I took out the 2 bolts with no problem, but i'm having trouble getting the starter to drop down. any suggestions? try moving the starter up and to the front, the ...

...located on the driver side of your truck. It should only be 3 bolts that are 9/16. remove those and the wiring connecting too the starter. pull it out and you will be able too put a new one right

...bolts? The starter bolts to the engine, and you may be able to leave it in place, but I would remove it to get the extra "wiggle" room. If you can't get to the top bolts with extensions and universal ...

...where is it located. thankyou Yes it does, it is the small round canister bolted to the top of the starter. The starter is bolted to the bottom rear of the engine on the passenger side. Yes on top

why does the starter motor make loud noises when starting the engine Bad starter drive or ring gear.mounting bolts loose. Worn starter bearings,Engine out of time.

can i put a bigger starter in yes you can the small block and big block chevy all share the same bell housing so the bolt pattern is the same so you can use a higher amp starter