Questions & Answers for: Pontiac starter bolts

Question about 2000 Grand Am GT

2 Answers

...undo the 2 nuts on the cilinoid remove wires undo the 2 bolts that hold the plastic cover over the starter bolts remover the 2 starter bolts replace with new starter and do everything in ...

Ad

...starter has two bolts. make sure you are using self locking washers. you could also use thread tape or buy a tube of locktite. bolts are about 4-5 inches There is two bolts and sometimes a little one ...

Ad

...Starter motor. Torque the bolts to 66 ft. lbs. (90 Nm) for 2.4L engine or 37 ft. lbs. (50 Nm) for the 2.2L (VIN 4) engine or 30 ft. lbs. (40 Nm) for the 2.2L (VIN F) engine. Starter electrical ...

...starter mounting bolts Removing the starter mounting bolts Removing the starter Disconnect the negative battery cable. Raise and safely support the vehicle. Disconnect all wiring from the starter ...

...Starter motor. Torque the bolts to 30 ft. lbs. (40 Nm). Starter electrical connectors Negative battery cable 3.1L Engine Before servicing the vehicle, refer to the Precautions section. Remove or ...

starter-to-engine bolts, then carefully lower the starter from the vehicle. Fig. 4: The starter is attached to the engine with 2 mounting bolts (see arrows) Fig. 5: Unfasten the front mounting bolt (1

Question about 1999 Bonneville

1 Answer

starter-to-engine bolts, then carefully lower the starter from the vehicle. Fig. 4: The starter is attached to the engine with 2 mounting bolts (see arrows) Fig. 5: Unfasten the front mounting bolt (1

Question about 2001 Montana

2 Answers

bolts Starter motor To install: Install or connect the following: NOTE Before installing the starter motor to the engine, tighten the nut next to the cap on the solenoid BAT terminal. If this terminal

...bolts. Pull the starter out of the hole and move toward the front or passenger side of the vehicle. Disconnect the wiring from the solenoid. Fig. 5: Starter mounting for 2.3L engine - 1990-95 models ...

...bolts that hold starter on,several wires with neg cable on same hook up ?does starter have to be removed to get the neg cable loss Can neg cable to grouned to soe othet spot on frame? The negative of ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Pontiac Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Brad Brown

Level 3 Expert

19187 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...