Question about 2006 XL 1200 R Sporster Roadster
...On some models it is possible to pull battery and get to the wire. If not i would rather pull the battery tray than dig into the primary to get the starter bolts .For fear of a leak on
starter and the bolts that hold it on. Disconnect the battery cable at the screw post on the starter, 12 mm nut. There are two large bolts that hold the starter on that take an Allen wrench or hex key
Question about 2000 FLSTC Heritage Softail Classic
starter? I have removed all bolts & wires and I still can't remove the starter. I must be missing a clip of some sort. Did you remove the bolt that holds the starter jackshaft onto the starter? If
...bolts off starter put new starter on the same way Drain primary oil and remove outer primary cover, Remove starter Jack shaft bolt. now on starter side of primary remove the two allen bolts that bolt ...
...bolts on the starter ears get to them from rt side, Ground strap is also under one of these bolts loosen them now snug them back... then . remove primary cover there is a long bolt that holds the ...
...to loosen the oil tank mounts to provide clearance for starter removal... Install new starter in reverse order...Torque specs... Starter mounting bolts - 13 - 30 ft-lbs Jackshaft bolt - 7 - 9 ...
Question about 2000 FXDWG Dyna Wide Glide
...starter motor to come apart as the two long slender bolts that you removed also hold the sections of the motor together. The same when you install the new motor. It will come apart and unless ...
...bolt on end of starter gear, remove gear and jack-shaft. Unbolt positive cable from starter. Unhook other wire from starter. Remove two bolts holding starter on. Remove starter. Reverse to
Question about 2000 FXDWG Dyna Wide Glide
...two bolts that hold the starter Take the two bolts out with the pick up tool real close to the bolts. At this point a dropped washer is going to be real hard to find and retrieve. Lift the starter ...
Question about 2004 FXDL - FXDLI Dyna Low Rider
...can remove the starter. Replace starter in reverse order, tighten starter bolts to 20 foot lbs. of torque jackshaft bolt 100 inch lbs. of torque. primary cover bolts 10 foot lbs. of torque. Good ...
Usually answered in minutes!
681 Questions
595 Questions
586 Questions
644 Questions
456 Questions