Questions & Answers for: Ford starter bolts

Question about 1998 F150 Regular Cab

3 Answers

...bolts holding the starter on. there is one on the very top of the starter. need about a 12" extension to get to it. There are two bolts that hold the starter in place. You will need a ratchet with an ...

Ad

Question about 1999 Expedition

1 Answer

...starter mounting bolts (typically only 2 bolts) 4. Install new starter. Hand tighten mounting bolts 5. Secure both bolts to about 35 Lbs of torque 6. Connect power cable. 7. Connect the negative ...

Ad

...bolts Slide the starter motor from its mounting until you can gain access to the wiring. Integral connector Starter motor To install: Install or connect the following: Integral connector and tighten ...

Question about 1993 Festiva

1 Answer

...bolts and remove starter. It looks like two bolts come from other side and bolt into starter and 1 bolt goes thru the starter into the bell housing/motor. Do the oposite to install. Here is a picture ...

...of the starter and you could fit your hand up there to feel it and place the socket. The 3rd bolt is between the bottom and top bolts. Remove the 3 bolts and the starter falls right out. All the

Question about 1991 Thunderbird

1 Answer

starter mounting bolts, then remove the starter from the vehicle.To install: Position the starter motor to the engine, then secure with the retaining bolts. Tighten the mounting bolts to 12-15 ft. lbs

Question about 1991 Thunderbird

1 Answer

what size bolts on a starter and is there three bolts on a starter most starters have two bolts - a short one and a long one. if you take out the old starter, you should reuse the old bolts.

Question about 1996 Explorer

3 Answers

...starter bolts from the starter, and remove it! reverse this to put new starter back in! Starter Removal Disconnect the battery ground cable (14301). Raise and support the vehicle. Disconnect starter ...

Question about 1987 Taurus

2 Answers

starter retaining bolts-early model 2.5L shown On vehicles equipped with an automatic transaxle, remove the starter between the subframe and the radiator. For vehicles equipped with a manual transaxle

Question about 2006 Ranger 4.0

2 Answers

...bolts are tight. Tighten the positive cable to the starter. Ensure the cable is snug to the fitting. Connect the terminals to the battery. Ensure the vehicle cranks. The starter will engage without ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

2000 Ford Focus
2000 Ford Focus

3,749 Questions

1998 Ford Explorer
1998 Ford Explorer

2,998 Questions

2001 Ford Focus
2001 Ford Focus

2,612 Questions

1999 Ford Taurus
1999 Ford Taurus

2,348 Questions

2004 Ford F150
2004 Ford F150

2,636 Questions

Top Ford Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

xxxxxx xxx

Level 3 Expert

5117 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...