starting dryer When I press the start button it makes a humming sound. Sometimes it starts, and sometimes it don't. It's not starting hardly at all anymore. It's only started doing this about 5 loads ...
machine wont start I have a zanussi zwd14715 washer dryer, it turns on fine, i can select the relevant programme etc, but when i press the start button nothing happens, the time stays up,the programme
Question about IZ12 Front Load Washer
zanussi jetsystemiz12 start /pause button flashing wont start was working ok up till now i have cleaned filter out i even put on a new door lock thinking that was problem it just stopped after a wash ...
start light will not stop blinking when i try to start zanussi iz12 it will not start the start light will not stop blinking http://www.enet.electrolux.com/Prod/DB11019.nsf/Script?OpenForm
motor not starting Drum will not turn at start. Motor torque seems not enough. Thinking back to school days. Why does a single phase motor not start? Field shift problem? A potential cause of trouble ...
Question about FLE1416W Front Load Washer
Machine won't restart after reset, 'start/pause' button flashing. Zanussi FLE 1016 W (Aquacycle 1000 XC) Problem: Machine won't restart after interruption and resetting, 'start/pause' button remains ...
Question about FLE1416W Front Load Washer
Starts for 10 seconds but then stops and start button flashes Problem with Zanussi ZWD1627OW: On a wash cycle the door locks and cycle starts for about 10 seconds, but then it stops, the door unlocks ...
Question about ZJ1217 Front Load Washer
when starting the washer there is 3 clicks but wont start washing once the start button is pushed there is 3 clicks then all the lights start flashing but washer wont run Check the door lock.
Question about ZJ1217 Front Load Washer
iz141w model , start/pause light starts flashing when i try to start wash when i start the cycle for washing , it starts but stops just berfore water goes into it and the start/pause light starts ...
Question about ZJ1217 Front Load Washer
...When you select a cycle the display just flashes. No fault code appears and the machine will not start , the dispaly just flashes. Any ideas? A "Delayed Start" may have been programmed. Turn the ...
Usually answered in minutes!
327 Questions
237 Questions
124 Questions
99 Questions
84 Questions