Questions & Answers for: star 1100 running cylinder

...Star 650. It seems to be running on one cylinder. What do I do? First, determine which cylinder is bad. Touch the exhaust pipes to determine which is hotter.(the pipes get VERY hot so be quick or use ...

...1100 v star clasic I had the same problem with my 2000 V Star 1100. It started out like yours, only running with the choke on a little bit. It got progressively worse. Turned out to be cracked rubber ...

...1100 v star classic does not run on the front cylinder, has spark, has compression, front cylinder stays cold. Back cylinder runs on spark, fuel, compression, no problem. Give any throttle and bike ...

...1100 V-star classic, sat for a while before I bought it, front pipe is starting to blue and the idle increases after ya ride it for a couple miles. bike only has 3300 miles on it. could it possibly ...

...star 1100 rear cylinder is running hot it seems like the front cylinder is runing much cooler then the back cylinder what would cause this to happen and the bike is kind of choking when i ride it ,it ...

...Star 1100 in April. It just started doing the same thing again...running on one cylinder. What could be causing this repeat problem? Hi, Dianedauby you need "FIVE" things in order for a cylinder to ...

...1100 starter clutch replaced now wont start it appears as though its running on one cylinder, if i leave the choke on . If i remove the rear plug it still runs on one cylinder. What did i do wrong ...

...star classic 1100 when i crank the engine both cylinders fire but the front cylinder only stays running for a couple of seconds then it floods the cylinder....has good compression and it appears the ...

...star running on one cylinder Yamaha Star Forum Thread vstar firing on one cylinder http://www.sloneservices.com/SilverBack/Other-Stuff/V-StarShopManual99-07.pdf OEM parts for Yamaha ...

...me with my 2001 vstar 1100 i was having same trouble with coils i tested the ohms ,voltage and spark every thing looked good but was still not running on front cylinder until i replaced the