Questions & Answers for: standby work onkyo

it. also does the sytem automaticaly choose the correct audio out put This works for some Onkyo receivers Hold down the VCR buttton on the receiver (not remote) and press the main power/standby switch

...work - cannot get it out of standby mode and drawer will not open Had an Onkyo DV-SP301 that would only intermittently come out of standby. Found faulty resistor R2 on the power supply board (board ...

...standby mode and there is no manual on/off button on the sub. Any suggestions? The manual is available at retrevo.com. If you don't have the center and sub defined in the Onkyo they will never work. ...

...Onkyo TX-SR806 remote has recently lost its mind. The On/Standby switch no longer turns receiver on or off; must do it manually on the receiver. The Volume control is now reversed: when you press the ...

Onkyo system at the dealer ??. If its OK try resetting the system. Remember you will loose all your stored presets ( FM and customized settings ) and the Amp will go back to factory settings. While in

...work it out what ... on the display panel in standby mode there is small blue light says : hdmi any advice on, how to bring back standby light ..! thanks If Zones are turned on or, if a mobile device ...

Onkyo TX-SR805 Receiver power-on button not working, only the led red light indicator appears. Tried to reset by holding/press vcr/dvr & standby/on button, no result. Please help me solve this problem

Onkyo. The subwoofer out may be stuck off, even if the settings say its on. hold down the Video 1 and Power on/ Standby buttons. The display should say Clear, then enter standby turn it on and try the

Polk Audio PSW10 10’’ "&there’s no sound the standby light is red. Connect onkyo av-amp sub pre-out to line in and enter Onkyo av-amp speaker setting then subwoofer level calibration finally set +10db

Onkyo txsr313 receiver working mode but stuck, cannot working switches and remote? https://www.youtube.com/watch?v=gfJEw-VlpWY Hold the "VCR/DVD" button while pressing the "On/Standby" button, and the