Questions & Answers for: Pentair sta fuse

heater will not shut off when tempature is reached Hi, The thermostat has gone bad.... replace the t-sta and it will work again correctly. heatman101

...fuse on the control board and connections to the board. It still will not power on. Hear are the two suspect parts but I don't want to buy both. 77707-0013 Sta-Rite Max-E-Therm Heater Control Panel ...

installed a pentair superflo inground pool pump which replaced a sta rite, pump does not suction water from pool. make sure wiring correct if ok check intake union maybe loose check top seal

pool pump blows fuse bad motor replace whole pump

Pentair StaRite heater display reads "126" and won't turn off. After changing the thermister and resting power, display quickly read "r=5" then "126" which is where it is today. Display still won't ...

Heater runs about 1 minute and shuts off HLS is on high limit switch is open. it will open it water inside header gets over 135 degrees, or you have a faulty high limit switch

ignition lock out what does ignition lock out mean? it mean the heater treid to start 3 times and failed

how do I fix my Sta-Rite pool heater? I don't know what you want to fix! Be more specific! What is the problem?

what does it mean when it says ignition lockout heater tried 3 times to fire and was unsuccessful

My ritetemp 8022c not working after pushing the reset button.the mode is c° instead of f° press up and down at same time there is a jumper block on the back of the unit. set the jumper block to be for