Questions & Answers for: ssr 6 40 125

I need to know what kind of oil to put in my SSR EP20 model screw compressor SSR ultra coolant a synthetic base oil. I recommend ultra coolant by IR. This is a poly glycol base synthetic lubricant. ...

...SSR SR 125 pitbike. Is it SAE 30? You will need a multi grade four stroke motorcycle engine oil SAE 20-40 or similar, Make certain it says motorcycle oil, as the car oils can cause clutch ...

i need an exploded view of a ingersoll rand ssr up6 40 air end exploded view?

ssr-epe250 and need to change the pressure setting from online @93 & offline @ 103 psi. i need 125 psi. i just changed the controller and cannot get back to operating specs i need. controllers

...ssr 125 pit bike it starts fine but when you give it a little throttle it starts to sputter a little . it seems to run fine once you get going .i just finished breaking it in its got 2 hours on it. ...

I installed a used Ingersoll-Rand SSR-EP30 yesterday. When it reaches set pressure (110) and unloads, the air pressure continues to gradually creep up until it shuts down on high pressure...approx. ...

Ssr up series 30e-40 Ssr 50 - pe low sump press........shuts down compressor idling to long or inlet valve not opening

...assistance. (Not posting actual phone number here due to frequent fraudulent spam phone numbers posted on FIXYA.) ...

...40 air compressor and the ssr intellisys factory settings can be pulled up by pushing the load/unload button and then within 3 seconds push the "secret button" found just above the unload button and ...

...SSR-6-20-125 AIR COMPRESSOR NEED TO KNOW STEP BY STEP PROCEDURE FOR CHAINGING FROM BAR TO PSI,FROM C TO F TEMPRATURE ON THE DISPLAY SCREEN Ingersolll Rand website support section should be able to ...