no power ps252652 wont turn on what is the problem? More info, please.....What is the service number of yourPROSCAN TV ? Is there any power indication at all ? Tickingsound, squeal or LED blinking ? ...
replacment lamp I THOUGHT MY original lamp was burnt out, so I replaced it. However the TV new lamp only stayed on for 7 seconds then it died. The original red lamp light (on TV) came on again. I ...
Question about WD-62725 62" Rear Projection HDTV-Ready Television
wd-62726 Loud noise after cap fix I recently replaced the caps on my mitsubishi wd-62725, but after I plugged everything back in and attempted to fire it up, when I plug in the TV I hear a loud ...
Question about WD-60735 Projection Television
I changed the bulb and tv worked fine for a day. Now the tv shutsitself down after about 5 minutes.I turned the timer off and reset the system and the problem still exists, suspect a defective lamp...
Question about WD-52628 52" Projection HDTV
tv is turning off after 30 secs of being powered on then red lamp light goes on Ur lamp nust be replaced is dying.That why lamp light on.
My Mitsubisha WD 65838 dlp TV has a high pitch squeal coming from the back of the set. These HD TV sets are 100 times easier to fix when they actually still (mostly) work. Instead of waiting for the ...
Went to turn on tv and made high pitch noise like a jet engine. Made this noise a couple times and heard a fan kick on then power went off and red light came on. Colorwheel eeds replacement most ...
Question about WD-Y65 65" HDTV
My Mitsubishi WD-Y65 screen will not turn on. No sound will come out. It makes a noise like a high squeal, then the squeal slowly becomes lower. It sounds like an old looney tunes cartoon where wil ...
Question about WD-65638 65" DLP HDTV
What would cause my 65" WD 65638 TV to power on normally but after a few minutes it will start making a squealing noise in the back and the picture will start to get fuzzy and distorted an than shut i
Question about WD-65731 65" HDTV
my mitsubishi tv wont show a picture but it will make sounds bought a new lamp Hello, there are several things, a bad ballast board that provides the lamp with it's voltage to run it. Also a bad power
Usually answered in minutes!
1,423 Questions
661 Questions
252 Questions
240 Questions
221 Questions