Questions & Answers for: Chevrolet Malibu spark plug firing order

Question about 2004 Malibu

1 Answer

...spark plugs & oil, and now it want start. My car was working fine until I did all of that. It sounds like it wants to start but it want. you crossed one of the spark plug wires check the firing ...

Ad

...and the firing order # air filter, spark plugs, plug wires,---all 4 cylinders. 1-3-4-2, 3.1 v6 1-2-3-4-5-6.135 is in back of engine, 2-4-6 is in front. on 6 cylinder coil from left to right,

Ad

spark plug cables 2003 Chevrolet Malibu 3.1L SFI OHV 6cyl Spark Plug Wires - Removal & Installation 3.5L Engine Before servicing the vehicle, refer to the Precautions Section. NOTE Twist the spark

...spark plugs and put them in without knowing they have to have a special gap in the plug newer cars tell you what gap you need and their is a tool for making the correct gaps if they have not been ...

What is the spark plug firing order for a 2000 chevy malibu v6? 1-2-3-4-5-6 1-3-5 are in the rear 2-4-6 are in the front the coil order 1-4-6-3-2-5 counting from the driver's side

...spark plug wires 2001 chevrolet malibu I need to see the placement of the spark plug wires for a 2001 chevrolet malibu V6 3.1L do not have a diagram, but heres the firing order. 1-2-3-4-5-6, 1-3-5 is ...

Question about 2002 Malibu

1 Answer

...firing order for the spark plugs.it tries to turn over, but it appears to backfire,and just runs the battery down if your standing in front of the car and looking at the coil pack the order across ...

Question about 1999 Malibu

1 Answer

...SPARK PLUG WIRES WITH ANOTHER CYLINDER AND SEE IF YOU GET ANOTHER CODE. MAKE SURE PLUGS ARE GAPPED CORRECTLY. IF IT IS NOT A SPARK PLUG OR WIRE, SUSPECT A BAD INJECTOR. 301-306 IS CYL,1-6. ALSO MAKE ...

...spark plug wires in this model On this model it has a 3.1 liter v-6 the coil pack is near the firewall and coil pairing (firing order) 1-4,2-5,3-6 the front cylinders are the easy to replace that ...

...spark or both. Do this remove a plug wire or coil on plug the insert a screwdriver into the boot and then hold the metal part of the screwdriver 1/2in. from a metal part of the engine block then have ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...