Questions & Answers for: Stihl spark module

Question about Stihl Saws

1 Answer

...spark. If I motor the engine with a drill then it sparks but I think that it is too weak to jump the plug (new) gap under compression. It seems to me either the ignition module or flywheel magnetism. ...

Ad

...spark replaced module still no spark replaced spark plug 3 times set module at .003 used drill motor to turn fly wheel no spark If you have changed the plug and have it firmly earthed against the ...

Ad

new spark plug.but apears to have weak spark.Colr of spark is not purple,it's a silver color.I think coil needs replacement . Check the timing gap between the ignition module and the fly wheel

...apart to expose flywheel then ck for rust on flywheel at pick up if rusty clean set pick up clearance to that of a matchbook or ten thousands of a inch.if still no spark change condenser or

Question about FS 85 Weed Eater

1 Answer

...module then reassemble unit and test for spark ( spinning by hand will not work, you need to use the starter rope to get the needed RPM to create a spark). If you have no spark with the ground wire ...

Question about Chain Saws, 017, 019, 021, 023 & 025

1 Answer

...SPARK PLUG WIRE TO COIL If the lead is broken, depending on which saw it is, you can buy a replacement lead. Unscrew the wire from the ignition module and screw in the new one after you put the end ...

Question about Chain Saws, 017, 019, 021, 023 & 025

1 Answer

remove earth wire from ignition module, this should make sure the ignition module sends current to the spark plug and not to ground)Check spacing between flywheel and ignition module. 0.25 filer guage

Question about Fc-mm Edger Kit Sleeve Mm55 55 Yard Boss Fcmm

1 Answer

...spark tester attached, the On/Off switch will not shut the engine off. First remove the module and clean the mounting areas to be sure the module has a good ground. Leave the ground wire off the ...

...spark. It gets gas and sparks, but won't start. I tried adjusting the ignition module to as close to .30 as possible. theres your problem. air gap on the module is 10 thou not 30 thou. set proper and ...

...Module When Spark Plug is in The Cylinder I have spark to plug and spark tester when turning saw when spinning it over w a drill and socket with plug out of cylinder, but none with plug screwed in ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Stihl Saw Experts

Cindy Wells

Level 3 Expert

6688 Answers

john h

Level 3 Expert

29494 Answers

ADMIN Eric
ADMIN Eric

Level 3 Expert

39362 Answers

Are you a Stihl Saw Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...