Questions & Answers for: Maytag spark module

spark module by switching the right and left side burner wires at the module. Once you do that, if the right side works ok, but now the left doesn't, you can be pretty sure it's the module...Catriver.

...spark module on this model? The spark module should be behind the rear panel of the range, or behind the bottom drawer, mounted on the interior back wall. If you go to searspartsdirect.com, the part ...

spark module and not a wire harness problem you can pick up a spark module as sears for about $37 and it only takes a couple of minutes to install. Just pull off the back panel and replace the module.

...spark module. If your model number is correct the module lists for about $18 at appliancepartspros.com. Just type in your model number and look for item 11 (part number AP4098758) under the "Gas ...

...module has 8 or more wires connected, some going to each stove. I don't know what the part number is for the spark igniter, and I don't know if accessing it through the right side is best, although I ...

...spark module to spark call applaince parts pro 1-877-477-7278 tell them u need part number AP4101545 ignitor switch 18.00 dollars they sit below the top under neaqth the selctors you will have to go ...

...spark module" is an Invensys U-67340-95; also has these numbers on it: 7431PO51-60; DAR 03-012 and DAR 03-007. do i just need to replace the module? Hi, Here is a tip that I wrote that will help ...

spark module in oven. No one can tell me how to get to this oart and what I have to remove to find it. All I get is copies of manual. PLEASE HELP. waiting your reply Hi, It is not the spark module and

...SPARK MODULE. To check it,it can be found inside the right side panel on the lower leg mounted to a bracket,by removing the storage drawer you should see the bracket on the lower right side. To check ...

spark control module. When I plugged it in, it now sparks non stop. How can I tell where I have completed the circuit to correct this problem? Try swapping the old module back in. If that doesn't work