Question about 24-24G-1 Gas Kitchen Range
spark or clicking, right. Is this the top burners and do they all do this? If the ignite module runs too long it could over heat and burn out. But if they are all doing this you have a problem with it
Question about 24-24G-1 Gas Kitchen Range
...spark module for 6 burner gas stove on DCS gas oven/ Unable to see how I can exchange module for spark unit Unable to lif front plate w burner knobs in the way. Is the module behind this plate? Is ...
spark module needs to be replaced and wanted to charge me for 3 hours of labor to replace at $90/per hour. Does this sound right? Is this the problem or could it be something else? Hi, it is possible,
Question about RGS-305 Professional Gas Kitchen Range
...if the burner won't stay on, either the igniter or the ignition module (or both) are bad. If the burner ignites and stays on but the spark module keeps trying to ignite, the module must be
Question about RGS-305 Professional Gas Kitchen Range
...spark module or the wiring, it was one of the little rotary switches that sit behind the burner control knobs. It shorted out (verified with an ohm meter). The switch is made by State Tool & Mfg. ...
The igniters will not stop sparking on my dcs cooktop when I turn the burners on. This happens with all burners. Because this is happening on all burners, i would say you have a faulty ground to the ...
...likely the spark module. All four are supposed to click when one is turned on, however they are supposed to stop when the burner ignites. Replace the module and test. Good Luck, Appliance ...
...spark module the burner is lit and go ahead and turn off the spark. That electrode and the wiring on it need to be replaced,from that burner back to the spark module. I found this place online that ...
...spark module to each igniter. I can not find them on the parts diagram. Are they standard genereic wires? no not standard. but you can replace them if you know a good place to buy high temp wires. ...
Question about RGS-305 Professional Gas Kitchen Range
...top by removing a thin bolt, and you can clear the holes with a paper clip. If all the igniters are sparking "AND" it makes NO DIFFERENCE which burner has been selected then either the electrical ...
Usually answered in minutes!
46 Questions
19 Questions
17 Questions