McColloch 310 no spark Sometimes I get a spark and sometimes none, what part do I need to get new or fix? Have you checked your wiring for insulation cracks, exposed wire or connections? Have you ...
...to test an ignition module on any small engine is on the machine. Simple and easy.First remove the spark plug , then remove the wire that connects the module to the kill switch, its located right ...
saw won't start, no spark, spark plug is dry Try a new spark plug first (gapped 0.020"), if still no spark, check the stop switch and wire first, then the ignition module located on the flywheel edge ...
...for a short time, it dies and I can't get it started again. Suggestions? Engines require 3 things. Spark, compression and fuel. And chainsaw need 2-cycle oil mixed with the gas. Assuming you have
Question about 13HP 338 Cc Portable Generator # FG6000MK
my 5700 watt 11 HP McCullough generator wont start. I'm getting good gas to the plug but no spark. The spark coil is bad if you have no spark Small engine repair. Part is expensive. Have you checked ...
Question about 16 Inch Gas Chain Saw MCC1635AK
Mac 16" chainsaw. no spark. saw sat for three Mac 16" chainsaw. no spark. saw sat for three years. would only start if fuel poured down choke. bulb was cracked and fuel lines eaten away. replaced
Question about FG6000MK 5700Watt 13 HP 338CC Portable Generator
no spark to the spark plug when pulling the cord First change the spark plug,if the problem persist,change the coil aka=spark plug cable and coil. If you need more help come back.Post / thumbs / ...
how doesw one change the spark plug? 1. Push STOP switch down. 2. Remove air cleaner cover. 3. Disconnect the wire connector (G) from the spark plug (H) by pulling and twisting at the same time ...
how do I change spark plug in my chainsaw old model around mid 80's have never changed spark plug before find where spark plug wire is connected to plug and disconnect very gently, remove spark plug ...
Question about 16 Inch Gas Chain Saw MCC1635AK
how to test spark on McCullough 2.0 chainsaw I would do it this way: 1) Remove spark plug, make sure it is clean, dry, and has the proper gap. 2) connect lead wire to plug 3) hold plug against motor ...
Usually answered in minutes!
311 Questions
93 Questions
31 Questions
30 Questions