Questions & Answers for: how do get solder to stick

Question about Computers & Internet

1 Answer

of it if the usb metal flat stick got snapped off,try to solder it back to its mini board, if you dont know how to solder..read from this site: http://www.kpsec.freeuk.com/solder.htm PS,rate pls... ;-

Ad

...the new motors to the panel the solders beads up and want stick. i've tried everything to try to make it stick. PLEASE HELP! What should i do to make the solder stick. you need an acid core ...

Ad

Question about 2GB Memory Stick PRO Duo Memory Card

1 Answer

...stick board was bent and now it does not detect. Can the flash memory chip be removed and then soldered on to another working Sony memory stick? if it would be very difficult, what are my

Question about 2GB Memory Stick PRO Duo Memory Card

1 Answer

...solder to stick to the outside of the potentiometers Use some fine sandpaper to clean a spot where you want to solder before you do the soldering. Maybe you will have to use some soldering flux or ...

...stick sticks going up and right on cod 4 and i cant get it to reset If it's been pushed really hard or perhaps dropped, it's possible that one of the solder joints has broken. Each analog control has ...

...stick when its damaged ! lots of de-soldering (to remove) (solder ****** working overtime) & lots of re-soldering fitting the new (or used) one ! Trust me....ive tried ! I can do it...but its not ...

Question about Bp860mp Battery Powered Soldering Iron

1 Answer

solder to stick to the metals to be joined...Judging by the iron that you have...it looks like it is mainly used for very small soldering applications where not too much heat is required...If you want

Question about 2000-2b09wm Laptop PC

2 Answers

...solder some place to stick. 3:Make sure to separate the broken wire from the ribbon a few inches as to not weld the good wires together when soldering.4: After you have the good wires away from your ...

Question about 2000-2b09wm Laptop PC

1 Answer

...stick to VERY GENTLY push legs to check contact. Patience will be required. If you find a lose leg, try a quick touch with NO solder first to see if it sticks. (Using solder may result in two legs ...

...Thanks in advance ;- Loose contacted solder terminals. Keep that stick handy always. Never give it up. There is no other remedy to this problem. If you have, an OLAKKA will do more good than a

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Computers & Internet Experts

Grand Canyon Tech
Grand Canyon Tech

Level 3 Expert

3867 Answers

Brad Brown

Level 3 Expert

19187 Answers

Cindy Wells

Level 3 Expert

6688 Answers

Are you a Computers & Internet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...