...of all, if the dispenser has a cone shaped cup inside, make sure it is inserted cone-side UP. The cup is designed to allow fabric softener to roll down the sides of it, NOT hold it. I hope this
...SOFTENER CUP TO CLEAN I CAN'T FIGURE OUT HOW TO GET THE FABRIC SOFTENER CUP OFF THE TOP OF THE AGITATOR TO CLEAN IT. ANY IDEAS. I'M SURE IT MUST COME OFF. i had this same problem. if you just twist ...
Question about SAV5710 Top Load Washer
...softener cup at the top center of the spindle before the wash cycle started, is left laying at the bottom of the tub. It looks like it is straight out of the softener cup without being mixed in with ...
...softener cup raising the level. In the softener cup, there is a tube loosely covered with a cap. When the level in the softener cup is raised high enough, a siphon effect is started and the softener ...
Question about Nexxt 500 WFMC3301 Front Load Washer
...softener cup, then your problem may be with the water valve assembly. The water valve assembly (as one complete unit) has a separate solenoid for hot and cold water temperatures, bleach and fabric ...
softener cup off of the top of the agitator Using a ratchet, an extension and socket; then remove the retaining bolt under the fabric softener cup. The agitator will lift off after the bolt is removed
...softener in the cup, up to the line. When the washer is ready to dispense the softener, it begins to add water to the cup, raising the level. As the level overflows the cup, it passes under the cup ...
...softener cup, you will find a gear that moves the agitator. It is made of plastic, or nylon. These gears tend to break sometimes. If it's not under the softener cup then unbolt the bolt under the ...
Question about Affinity ATF7000E Front Load Washer
...softener dispenser cup. When the cup is full the water siphons out and softener and water flow into the tub. If the liquid in the fabric softener dispenser is pure softener you may need a ...
Question about Affinity ATF7000E Front Load Washer
...Use very hot water and a washcloth to clean out the softener cup. When adding softener at the beginning of the load, only add the recommended amount and then fill the remainder of the cup with
Usually answered in minutes!
9,125 Questions
3,839 Questions
3,158 Questions
2,979 Questions
2,660 Questions