Question about 2004 Freestar
...there is no air left in system then you will need a scan tool to perform a abs service bleed.if you do perform the abs service bleed with a scan tool the brake pedal will be soft and start to
soft brake pedal after rotor replacement I took my wife's 2003 3.2 CL to Pep Boys to install new front rotors and brake pads, and to adjust the parking brake cable. After picking up the car, the pedal
...soft brake problem.i have replaced the rear shoes and adjusted rear brakes,also replaced front rotors and pads.i have also replaced the master cylinder.after bleeding brakes with engine off i can get ...
...brake pedal gets really soft and you have to push it almost to the floor for the brakes to engage. I tried bleeding the brakes again and that fixed the problem, but it is now back to being soft. Do I ...
brake pedal soft after changing pads and bleeding brakes front right brake hoes blew out and replaced it and changed pads.Bled brakes all four but pedal is still soft when car is running but gets hard
...brake pedal is still a little soft Vacuum bleeding ? By Yourself--- waste of time Lets stay with old school Put someone in the drivers seat to slowly push the pedal, as you open & close the ...
Question about 2001 Nubira
...brake pedal low after replacing rear steel lines, all rubber hoses and all calipers. system bleed car sops but pedal very soft Pedal pressed hard and both rear steel lines broke and now the pedal is ...
Question about 1985 K1500
...soft possiable brake booster. if you hear a hissing sound and truck runs rough if not possiable master cylinder. Ok what else did you do ? Check these things look for leaking lines calipers wheel ...
Soft pedal after bleed After Brake Bleed the pedal goes to the floor No leaks No Air In the lines? possibly bad master cylinder then If the vehicle has antilock brakes you have to do a pressurized ...
Question about 2001 Corolla
Soft pedal after replacing brake calipers have bleed brakes but still soft pedal would this be air trapped in the abs unit can I just turn ignition to on position and re bleed brakes If you have ABS ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions