Questions & Answers for: Chevrolet C1500 soft brake

...brake pedal sticks on the floor. Any ideas? the only thing left unless you have a leak is the proportioning valve A soft pedal can also be caused by badly adjusted rear brakes but you shouldn't ...

soft My brake pedal on my 98 chevy s10 is soft and goes all the way to the floor. I have replaced the brakes more than a few weeks ago and all of a sudden they went soft so I bleeded them but still no

in correct order still have a soft brake pedal? You still have air in the system. You will have to bleed more. I had to bleed a quart of brake fluid out of each wheel to get good brakes on my 1996 GMC

brake pedal soft going to floor, what causes this? youhave eather a brake line failure or if you have drum brakes in the rear your Brake cylinder might be bad eather way dont drive this car before its

...brake back up ,but the brakes are soft agian. What can I do? IF your brake pedal went to the floor, then you have a brake fluid leak somewhere. Even though you filled the reservoir with brake fluid, ...

...brake light came on with I P on the top. The pedal is very soft. I filled the master cycl. and pump the brakes they cam up but a few seconds later they were soft again. What can I do to fix this ...

...BRAKE PEDAL, EVERTHING IS AJUSTED OR NEW, PUMPS UP GOOD ENGINE OFF, SOFT ENGINE RUNNING Sounds like you have air in the lines, or rear brakes out of adjustment. Make sure the rear brakes are adjusted ...

...brake pedal feels soft maybe sponggy? Engine running or off my pedal is not solid enough? Can you share what might be my problem? I also self adjust rear brakes backing up and no strong results? Can ...

...soft and brake light stays on? I have replaced new brake shoes,disc pads,new master cylinder,brake booster and ABS Module.Still no solid pedal? Brake lights is on? Did you bench bleed the MC before ...

...brake pedal till i start the truck then it gets soft all new brakes ...bleed the system...and have a good pedal till i start the truck then it's spongy changed master cylinder...and the ...