Questions & Answers for: snugli

Question about Snugli Front & Back Baby Carrier

2 Answers

Front carrier to back carrier Tossed my Snugli instructions too quickly and can't figure out how to covert it from a front pack to a back pack. Help! to make it a backpack you just put the baby in and

Ad

Question about Snugli Front & Back Baby Carrier

2 Answers

No date of manufacture on my snugli I need a replacement instruction manual for my snugli to go from chest to forward facing. I go to the evenflo replacement parts page but I can't find any date of ...

Ad

Question about 1997 F150 Regular Cab

1 Answer

Changing front wheel bearings 1997 F150 2WD How tight do these need to be...is there a specific torque that needs to be done or just make them snug. Can they over tightened? snug the bolt and put in ...

Question about Snugli Front & Back Baby Carrier

2 Answers

instructions for putting on a Snugli I was given a new Snugli baby carrier with no instructions. Please help. Call Evenflo customer service at 1-800-233-5921. I threw away my instructions too. I ...

Question about Snugli Comfort Vent Baby Carrier

2 Answers

Need instructions on how to strap baby in rear facing in Evenflo Snugli Comfort Vent Soft Carrier go on the website type in make and model and option to read or download instruction manual will come ...

My 2008 aveo5 is leaking what looks like oil. I looked underneath the car and it looks like it is leaking through the gasket on the engine that is to the left of the drainplug. That is if you are from

installed new spider injector. 1999 yukon 5.7 - now plenum vacuum leak I believe. It has a high pitched squeal when started and stops the second I shut it off. what is the torque sequence for the ...

I have an oil leak (four to five drops after shutting off) I replaced the crankcase gasket and I still have a small leak after shutting the bike off. Any clues as to where else the oil is coming from?

Tensioning dial wont tension enough When new (2012) I was able to 'tension +-' the chain to be snug before locking it . At some point I found that when I needed to snug the chain , I could not

Question about RAYPAK REAR HEADER GASKET CAPRON 185405

1 Answer

tightening sequence for a 91 c-10 Just shy of snug start in the middle, then work your way out criss crossing. Once sorta snug, then tighten a little more on the 1st pass in the same sequence: middle

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Baby Gear Experts

Jennifer Rock
Jennifer Rock

Level 2 Expert

153 Answers

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29492 Answers

Are you a Baby Gear Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...