Questions & Answers for: slash shield remove

slash shield. Then look for a tensioner just in front of the oil pan. It should be in between the crank pulley and the compressor pulley. You will need a Torx socket to get in there to relieve tension

...slash shield Radiator support access panel Rear alternator bracket from engine Mounting bolts Duct on back of alternator Wires Bracket Alternator 4>1998 Seville, 2000-01 Deville Before servicing ...

...slash shield. You will than be able to use a 15 or 13 mm wrench on the center bolt of the tensioner pulley to release the tension. Remove the belt. There will be two bolts that hold the tensioner to ...

...in the system!) the only way of finding the source of the leak is the hard way, start by removing slash shields, and peripheral plastic engine covers, start the vehicle and allow it to reach ...

slash shield. You will need to remove the tire and some retaining fasteners from the slash shield to get to it. On the drivers side behind the front of the wheel well. Most clips are reusable, however