i have a suzuki rm 125 1994 model when i pull the clutch lever in to put it in gear the clutch doesnt work t jst crunches into gear Adjust the clutch cable to allow about 1/4" free play at the end of ...
...nut. The cable end "ball" will come out with the help of needle nose pliers also. Pull the cable slack up to rotate the "ball" out of the throttle tube. Hope this
my rm 80 1stand 2nd gear locks wheels If your rear wheel is locked up in first and second gear with the engine running, this is not a good sign. Have you ever ran the bike without oil in the ...
1978 suzuki dr 370 motorcyle just started having a problem. When in neutral the transmission makes a popping type noise intermittenly. when this occurs it tries to jump into gear. ant idea The popping
bike keeps jumping out of gear my rm 125 keeps jumping out of gear as i get in to power band? Either your gear selector adjustment needs to be re-set (right hand side of motor inside the clutch cover,
...this will now be the focal point for tightening up the chain...this tighter part must have "some" slack in it...id say give it about 1/2 inch...now tighten up the chain adjustment nuts finger tight ...
Transmission will shift into, or out of gear, but will not spring back into position. For instance. If you want to shift into first gear, you have to push down on the shift lever, then back up just a ...
...no problem, whats wrong? the chain is to tight when you put it into gear you loose 2-3 links of slack and if its to tight you cant change gear move the back wheel closer to the swing arm that ...
timing chain adjustment cam chains are normally tensioned automatic so if slack then check its working and all guides ok , if yes replace chain asap !
I TELL YOU.. 1. Loose the cable adjuster at the handle bar.. run the adjuster in - (give it as much slack as you can) 2. The clutch actuator lever on the engine case should be able to move about 8mm (
Usually answered in minutes!
329 Questions
42 Questions
35 Questions
1 Questions
