...camry? OVER THE CRANK PULLEY BETWEEN TENSIONER AND WATER PUMP DOWN TO PWR STEER PUMP PULL ALL SLACK TO THE ALT . PULL TENSIONER TOWARDS FRONT OF CAR AND INSTALL TO
...is stuck. 1993 toyota camry wiggle the shifter and run it through the gears with light pressure applied. Just enough pressure to take up any slack but not so much that you keep it from popping
...pulley. Then loosen the bolt that protrudes from the back of the pulley. This will let the belt go
...long bolt that needs to be loosened. As it loosens push the alternator down and you will get enough slack to remove the belt. For the power steering belt, remove the front passenger-side wheel. You ...
I changed the water pump, and the timing telt appears to be a little off need to make sure all the slack is on the tensioner side when fitting the belt
...inside of waterpump up to alternator then all way down to powersteer pump slide off water pump for slack from pwr steer to tensioner pull like crazy putting slack back on waterpump good luck please ...
does timing chain need to be repaced on 4cyl at 150000 miles? usually when the slack adjuster is at it's stop, is a pretty good sign that the chain is ready to be changed. Any reputable mechanic can ...
...slack towards the tensioner trying not to move the gears and check your marks and if all good release the tensioner and then tighten. put the crank bolt in and turn the engine over 360 degrees and ...
Put the timing belt on but still got slack If you have slack you either have the wrong belt, or your tensioner may not be working properly
Why can't I open the trunk from inside the car? The inside lever has slack and will not open trunk lid. bad cable. or detacted. or latch jammed. find any mech, this is childs play to all but can be ...
Usually answered in minutes!
1,828 Questions
1,753 Questions
1,565 Questions
1,303 Questions
1,134 Questions