Questions & Answers for: Ford F-350 slack in gears

...the breaker bar handle straight up. now pull the handle towards the passenger fender until you get slack in the belt to remove.(i think its a 15mm socket but not

Differentail slack / back lash Can the slack / back lash be adjusted out of the rear End?or what is the best fix to remove this slack. if your talking about turning the driveshaft both ways and ...

how to change brakes on a 1979 f800 back pull the wheel let the slack adjustment go in then pull them off put new ones on readjust front well is the same way if its got brake fluid you depresse the ...

from start up on my f350 super duty when I put it in gear for the forward gears I have to rev the motor to get it to engage so I can go but reverse will go right in to gear just fine and the forward ...

...your off a hair on the timing of shafts it will set a code every time. Also if there is any play or slack it will do the same thing. In you case you need to have the timing belt check and or reset. ...

...slack so the gears are not smashed. You also have a joint in the steering rod. It can have a fiber coupler or be similar to a U-joint. You would need to hold the steering box side of this joint ...

torque spec for 10.5 ford ring gear Here is all the specs Assembly Specifications: Cover Bolt Ft. Lbs. 28 Pinion Brg. Preload In. Lbs 16-29 Pinion Brg. Preload In. Lbs 8-14 Used Ring Gear Backlash ...

1986 F350 6.9 automatic will not drive but goes into gears. The problem first became noticed at a stop light after hitting on the gas it wouldnt go. So i kicked into second on a automatic transmission

****** in f-350 does not go into gear,shifter moves no gears engage,1-2-3-4,,it does nothing and only thing that works is park,reves up in gear ,nothing happens,,it would roll away in gear You have a ...

how to adjust slack on rear end on a 08 f350 If your problem is a clunking when putting it into drive or reverse then usually taking the drive shaft apart and greasing the slip yoke solves that ...