clutch play/slack to your personal preference. Soon as you are satisfied (number of tries clutching/engaging gears), then the locks could be tightened in place. Good luck and thank you for using FixYa
...be an adjuster either at the clutch handle or at the transmission. Just take most, not all, of the slack out of the cable. You should be back to normal now. Please rate this solution as "FixYa" or ...
...slack and when i rotate the back wheel with the clutch in there is a tight spot in the 'gearing' how costly is this going to be ? bike is a 1995 plate. I have been a bike mechanic for over 10 years ...
...slack adjuster either at the throttle itself or at the top of the carburator you will have to slide the boot out of the way adjust accordingly tighten jam nut and you're good to go :-) here's a good ...
...other gears are fine when rolling have you checked your chain tension because that can cause it to clonk if to slack and also check the condition and play in your cush drive rubbers on the back ...
slack? How would I know, and how do I fix it? The problem is not the clutch. The problem is bent shift forks in the transmission. I hate to tell you this, but it will not be cheap to fix. Some special
...through appropriate cable holders and to the brakes-you hold the brake calipers shut-remove excess slack from cable by pulling on it with pliers and back off a little before tightening the nut ...
1985 kawasaki kx 125cc acts like choke is on sometimes when i go up a hill no matter what size, it bogs down and at the end of every gear to me it just seems like it has a little more to go but it can
...gears or cut-outs on end of cam. Tried all but wont start. Which mark must be used on casing what type of bike. usually there is a make down on the stator housing, pointer or notch, then on the ...
Usually answered in minutes!
239 Questions
197 Questions
175 Questions
157 Questions
126 Questions